I have a brand new wildfire v.2 board, which I bought new and for various reasons just got around to using it. So far it only runs the "buildtest.ino" in IDE 1.6.13 past the MAC address print and restarts - same with other sketches - never connects but gives no errors - just stops executing and restarts:
Hello, CC3000!
RX Buffer : 512 bytes
TX Buffer : 512 bytes
Initialising the CC3000 ...
Firmware V. : 1.19
MAC Address : 0x08 0x00 0x28 0x57 0x5A 0x34
Deleting old connection profiles
Attempting to connect to FiOS-FO85F-5G
Hello, CC3000!
etc etc etc
It is set up on a serial port as a "wildfire v.2[stk500] definition. It apparently needs many updates taking much time. Would it be smarter/easier just to get a new v.4 and forget this one?