Hi
I was given an egg from work to try to set up at home (as I think there were problems there).
I managed to connect it to my laptop and to get the plugin working in Chrome
I tried to set up Wifi connection and it failed. I assumed they's maye be been trying options at work, so I did a
restore defaults
I dicsonnected and reconnected and tried again entering my wifi ssid and password
I know the SSID is correct as I have checked it - and this laptop and my phone are running off it.
When I connect I get
+------------------------------------+
| Welcome to Air Quality Egg 2.0 |
| NO2 / CO Sensor Suite |
| Firmware Version 2.1.9 |
+------------------------------------+
Compiled on: Sep 21 2016 13:41:28
Egg Serial Number: egg00802f7dc4080132
Info: Tiny Watchdog Initialization...OK.
Info: Slot Select Pins Initialization...OK.
Info: SPI Flash Initialization...OK.
Info: SD Card Initialization...Fail.
Info: Current firmware signature: 342996 48051
Info: SHT25 Initialization...OK.
Info: NO2 Sensor AFE Initialization...OK.
Info: NO2 Sensor ADC Initialization...OK.
Info: CO Sensor AFE Initialization...OK.
Info: CO Sensor ADC Initialization...OK.
Info: RTC Initialization..Fail
Info: ESP8266 Initialization...Failed.
Info: Startup config integrity check passed, but mirrored config differs, attempting to restore from mirrored configuration.
Error: Mirrored configuration is not valid, cannot restore to last valid configuration.
Enter 'aqe' for CONFIG mode.
OPERATIONAL mode automatically begins after 12 secs of no input.
It says it scans for networks but finds none.
Any ideas?
Thanks
Ian