Broken connection to MQTT

@vicatcu And this is with the “aqe” command

 -~=* In CONFIG Mode *=~-
OPERATIONAL mode begins automatically after 5 mins without input.
Enter 'help' for a list of available commands, 
get settings
 +-------------------------------------------------------------+
 | Preferences/Options:                                        |
 +-------------------------------------------------------------+
    Operational Mode: Normal
    Temperature Units: Celsius
    Backlight Settings: 60 seconds, ON at startup
    Sensor Sampling Interval: 5 seconds
    Sensor Averaging Interval: 60 seconds
    Sensor Reporting Interval: 60 seconds
    SoftAP Config: Enabled
 +-------------------------------------------------------------+
 | Location Settings:                                          |
 +-------------------------------------------------------------+
    User Location: Disabled
    GPS: Not installed
    User Latitude: Not set
    User Longitude: Not set
    User Altitude: Not set
 +-------------------------------------------------------------+
 | Network Settings:                                           |
 +-------------------------------------------------------------+
    MAC Address: 5C:CF:7F:19:81:CA
    Method: Direct Connect
    SSID: Censores
    Security Mode: Automatic - Not Yet Determined
    IP Mode: Configured for DHCP
    Update Server: update.wickeddevice.com
    Update Filename: aqev2_pm_esp
    NTP Server: Disabled
    NTP TZ Offset: 0.000000000
 +-------------------------------------------------------------+
 | MQTT Settings:                                              |
 +-------------------------------------------------------------+
    MQTT Server: mqtt.wickeddevice.com
    MQTT Port: 1883
    MQTT Client ID: egg0080301997080120
    MQTT Authentication: Enabled
    MQTT Username: egg0080301997080120
    MQTT Topic Prefix: /orgs/wd/aqe/
    MQTT Topic Suffix: Enabled
 +-------------------------------------------------------------+
 | Credentials:                                                |
 +-------------------------------------------------------------+
    MQTT Password backed up? [* means no]
    Private key backed up? [* means no]
 +-------------------------------------------------------------+
 | Sensor Calibrations:                                        |
 +-------------------------------------------------------------+
    PM Offset [V]: 0.149741792
    PM Baseline Voltage Characterization:
        idx	temp [degC]	slope [V/degC]	intercept [V]
        ---------------------------------------------------------
        No valid entries found.
    Temperature Reporting Offset [degC]: 3.25
    Humidity Reporting Offset [%]: -5.06
 +-------------------------------------------------------------+
 | note: '*' next to label means the setting is not backed up. |
 |     run 'backup all' when you are satisfied                 |
 +-------------------------------------------------------------+
AQE>: 
 @=============================================================@
 # GETTING STARTED                                             #
 #-------------------------------------------------------------#
 #   First type 'ssid your_ssid_here' and & press <enter>      #
 #   Then type 'pwd your_network_password' & press <enter>     #
 #   Then type 'get settings' & press <enter> to review config #
 #   Finally, type 'exit' to go into OPERATIONAL mode,         #
 #     and verify that the Egg connects to your network!       #
 @=============================================================@
AQE>: