I have down loaded the Wicked_Stepper motor library and installed it. I have loaded the example of code to confirm that it works with my stepper motor. I have installed a second stepper motor and it rotates at the same rate as the other and the same direction. I have almost Zero coding experience but a lot of tenacity. After numerous attemps to get the steppers to operate in different directions and speeds I have come up with some questions.
Question #1) Does the Wicked Shield use the same commands as the Arduino?
#2) If it requires different coding and or words where can I find reference to these
#3) What all needs to be instructed in the (setup) portion of the code and can any of
that be changed further into the program (loop).
#4) Is there a complete list of the command words and syntax for the Arduino and
Wicked Shield
Insight into any of these questions would be greatly appreciated. Also if I am asking these questions without proper focus please let me know what I actually be looking at! Thanks all in advance for your assistance!
Terry Cummins